Alliedassault - View Single Post

1080jibber · 03-05-2007, 02:14 PM

[quote="TGB!":f656d]Its the firmware hack. I bought it pre-modded. The problem was that the discs would SOMETIMES load up. . .and most of the time would not. It kept on giving me an "Open Tray" error - and for like an hour, I searched online finding out where I go to start the fucking game. . .not realizing that if the game was to play it would say PLAY GAME where OPEN TRAY was displaying.

I found out that on some firmware or other - the laser goes "off track" into dead territory and doesnt go back to reading the disc - and stop spinning. So I spent about 4 hours of cursing getting the pos open. . .to apply a bit of rubber band to keep the laser from going off-track. At first it didnt work. . .but once i trimmed the band up a bit, I got it up and going.

What I wouldnt give for a fucking modchip though, but something tells me with this laser behavior - Id still get the same problems.

Still the shit works so Im not going to complain - for about 15 minutes there I thought I broke the damn thing.[/quote:f656d]
you should update the firmware, its really easy to do. i did my Hitachi 78fk, and did some sammy drive for some other people. i got a free via vt6421 (i didnt need the card for my Hitachi, but needed it for the sammy drives) card out of it plus money for DL disc's.

	(#73)
1080jibber is Offline 1st Lieutenant Posts: 4,435 Join Date: Jan 2002 Location: American't	03-05-2007, 02:14 PM [quote="TGB!":f656d]Its the firmware hack. I bought it pre-modded. The problem was that the discs would SOMETIMES load up. . .and most of the time would not. It kept on giving me an "Open Tray" error - and for like an hour, I searched online finding out where I go to start the fucking game. . .not realizing that if the game was to play it would say PLAY GAME where OPEN TRAY was displaying. I found out that on some firmware or other - the laser goes "off track" into dead territory and doesnt go back to reading the disc - and stop spinning. So I spent about 4 hours of cursing getting the pos open. . .to apply a bit of rubber band to keep the laser from going off-track. At first it didnt work. . .but once i trimmed the band up a bit, I got it up and going. What I wouldnt give for a fucking modchip though, but something tells me with this laser behavior - Id still get the same problems. Still the shit works so Im not going to complain - for about 15 minutes there I thought I broke the damn thing.[/quote:f656d] you should update the firmware, its really easy to do. i did my Hitachi 78fk, and did some sammy drive for some other people. i got a free via vt6421 (i didnt need the card for my Hitachi, but needed it for the sammy drives) card out of it plus money for DL disc's.