[Arkan]

These are the settings i'm using with a 4 port Linksys router with 2 computers hooked up.

SETUP TAB
Lan IP = 192.168.1.1 (router IP)
subnet mask = 255.255.255.0 (default)
select "static IP"
WAN IP = your provider IP found in "ipconfig"
subnet mask = same # given on your "status" tab
DNS = same #'s given on your "status" tab (i had 3 sets of DNS IP's)

PASSWORD TAB = default settings

STATUS TAB = read only settings

DHCP TAB
enable DCHP server
start IP of 192.168.1.100
enter your DNS #'s
all other settings default

LOG TAB = default settings

SECURITY TAB
exempt computers enabled
from IP 192.168.1.10 (IP of computer # 1)
to IP 192.168.1.20 (IP of computer # 2)

ADVANCED TAB SETTINGS
FILTERS
SPI disabled
block WAN request enabled
multicast pass enabled
IPSec pass enabled
PPTP pass enabled
remote manage disabled
MTU disabled

FORWARDING
port 12200 to 12220 (TCP & UDP enabled) IP=192.168.1.10 enabled
port 12300 to 12300 (TCP & UDP enabled) IP=192.168.1.10 enabled

DYNAMIC ROUTING TAB = default

STATIC ROUTING TAB = default

DMZ HOST TAB
dmz host IP = 192.168.1.0

ok, thats the router settings. Remember to set each computer on your system to "static IP" and enter the IP that you assign. My computer IP for comp#1 = 192.168.1.10 and IP for comp#2 = 192.168.1.20. Enter the DNS #'s given in the "status tab" into each computer. You enter this info in the TCP/IP properties settings like [HellBaby] described.

This configuration is working for me but i'm still having trouble with GameSpy seeing my server clearly. I'm probably missing some port #'s for GameSpy. Anyone with GameSpy port #'s?